Recessed lighting sits flush with the ceiling, with no hanging fixture to interrupt the room. Most Bell County homes built more than 20 years ago never had it installed, and it is often the first upgrade homeowners request during a renovation.
We install recessed lights in existing ceilings and new construction alike, using IC-rated fixtures near insulation and calculating spacing so no corner of the room gets left in shadow.
A dark hallway, a flickering fixture, or a porch light that stopped working months ago is more than a cosmetic problem. Poor lighting can affect safety, comfort, and how your home feels every day. Dr. Watts Electric installs and replaces lighting fixtures across Bell County as part of our full Licensed Electrician Services lineup.
We install flush mount, semi-flush, pendant, chandelier, vanity strip, and track lighting, and replace fixtures that are worn out or no longer fit the room. If there is no existing wiring, we can run a new circuit and handle the wiring, electrical box, and fixture installation in one visit. Every project is tested before we call it finished.
Patios, pathways, gardens, and driveways all benefit from lighting done right. We install low-voltage landscape lighting, line-voltage fixtures for walls and posts, and decorative options rated for wet or damp locations and grounded to code.
Homes near Lake Belton and Stillhouse Hollow Lake, with larger lots and outdoor living spaces, are some of our most frequent outdoor lighting projects.
A well-lit property deters unwanted visitors and helps your family move safely at night. We install motion-sensor lights, dusk-to-dawn lights, floodlights, and camera-integrated security lights positioned at front doors, garages, driveways, and side gates. Homes needing full-property coverage can also pair this with our Surge Protection in Bell County, TX service to protect the connected equipment.
A covered porch or back patio becomes usable at night with the right lighting design. We install porch ceiling fixtures, post lights, step and rail lighting, and pergola fixtures, all rated for the humidity and storms Central Texas summers bring.
A ceiling fan pushes cool air down in summer and pulls warm air from the ceiling in winter, running your AC less either way. We run new circuits and install fan-rated electrical boxes where needed, since a standard light box is not built to support a spinning fan safely.
LED bulbs use a fraction of the energy of incandescent bulbs and last far longer, but the most common LED retrofit problem is dimmer incompatibility. We handle retrofits for recessed cans, fluorescent tube replacements, and under-cabinet strips, replacing any incompatible dimmers in the same visit.
New construction and full renovations are the best time to get lighting right, since adding circuits after the drywall is up gets expensive fast. We calculate fixture spacing, plan circuit loads, and design lighting layers suited to how each room gets used, working alongside our Electrical Panel Upgrades in Bell County, TX team when a project needs additional capacity.
Some lighting projects need more than a fixture swap. Adding a dedicated circuit for outdoor lighting or a large fixture package sometimes calls for panel capacity an older home does not have, and our Electrical Panel Upgrades in Bell County, TX team can confirm whether your panel supports the project before installation day.
A whole-home assessment looks at every room, fixture, and outdoor area, checking for code compliance, efficiency, and coverage gaps. You get a written plan afterward listing every recommendation, the cost, and the order the work should happen in.
A surprising number of lighting service calls trace back to a mismatched dimmer, a fixture rated for indoor use installed outdoors, or a ceiling fan hung on a standard light box that was never built to support the weight and motion.
These mistakes are common with DIY installs and even with some less experienced contractors. We check for them on every job, whether we installed the original fixture or not.
A whole-home lighting assessment or a full outdoor lighting package is a bigger investment than swapping a single fixture. We offer financing options for qualified homeowners so a larger project does not have to happen all at once.
You tell us what you need, whether that is a single fixture or a full lighting design, and we get you on the schedule. A licensed electrician checks your existing wiring and circuits, gives you a flat-rate quote, and completes the work at a time that fits your schedule.
Every fixture, switch, dimmer, and outdoor light gets tested before we pack up. If something is not right, we fix it before we leave.
Belton, Temple, Salado, Harker Heights, and Killeen homeowners all call on us for lighting work. Our full Bell County Service Area page lists coverage for every city we serve.
Lake properties near Stillhouse Hollow tend to call us most for outdoor and landscape lighting, while new construction along the I-35 corridor more often needs a full interior lighting plan before the first residents move in.
Most electricians install whatever fixture you point to. We look at the room, the existing wiring, and how the space gets used before recommending anything, which is why our results tend to hold up years later instead of needing a redo.
Decades of Central Texas lighting and wiring experience
A design-first approach that calculates spacing and circuit capacity before any install
Every installation compatible with modern LED technology
Flat-rate pricing before any work begins
Rated 4.9 out of 5 by more than 500 Bell County homeowners
Cost depends on the number of fixtures, whether new wiring is needed, and the fixture type. We give you a flat-rate quote before any work begins.
Usually not for an existing circuit. Running a new circuit from the panel may require a permit, and we handle that paperwork when it applies.
The dimmer and bulb are not compatible. We replace the dimmer with an LED-compatible model and the flicker goes away.
Outdoor fixtures are built for wet or damp conditions. Indoor fixtures will corrode or become a hazard if installed outside, so we always match the fixture to the location.
A standard replacement takes one to two hours. Jobs needing new wiring for a ceiling box typically take two to four hours.
Yes. Vaulted ceilings need a downrod and angled canopy bracket so the fan hangs level, and we bring the right hardware for that setup.
A general guide is one recessed light for every four to six square feet of ceiling, depending on brightness and ceiling height. We calculate the exact count for your room during the visit.
Yes. Texas electrical code requires GFCI protection for outdoor outlets and certain fixture locations, and we install all outdoor lighting to meet that standard.
We hold proof of licensing and insurance on every job, and your quote is the price you pay with no hourly billing or added charges once the job is finished. If we uncover a bigger wiring issue mid-project, we explain it before doing any additional work.
A dark room or a broken fixture has a straightforward fix. Call (254) 939-3534 or schedule online, and a licensed electrician will design and install lighting built for how you use your home.
